Z Automotive TaZer JL

Z Automotive TaZer JL


Plug and play installation in two simple parts: a bypass module plugged in above the OBD2 connector and the TaZer JL plugged into the OBD2 connector.

There are two sets of features – those that program the vehicle to accommodate modifications made to the Jeep, and the “live” features that run only when the Tazer JL remains plugged in.

These are all accessed using the dash display, using steering wheel buttons to navigate the menus.

Settings – once the Tazer is “married” to the Jeep, the following menus can be accessed. Unmarrying the Tazer JL will bring the settings back to stock.
Perf menu:
Adjust for alternate tire sizes up to 41″
Adjust for alternate axle gear ratios
Adjust for an alternate transfer case LO range ratio

TPMS menu:
Disable TPMS system if desired
Change front/rear TPMS warning PSI limit

Radio menu:
Disable Backup camera
Enable Cargo Camera input
Enable CD audio input
Disable TravelLink (weather warnings included)

Lighting Menu:
Change DRL region (type)
Change DRL location
Disable DRL Dropout
Enable Fog lamp output
Disable Fog lamp dropout
Set LED 3rd brake light type
Set LED tail lamp type
Set Trailer Tow output for use with Mopar kit

Other menu:
Enable Aux switch settings on the radio
Enable Blind spot detection

Live features – these run only while the tazer is plugged in:
Light shows: Can be accessed from the key fob or from the on-screen menu. 6 pre-set light shows and 3 make-your-own shows included. Set from the factory to only operate when parked, but can be unlocked for off-road and emergency personnel use.

Disable Navigation in-motion lockout – enter addresses while the vehicle is moving
Auto Traction Kill – can be set to turn off traction control upon start-up
Auto StopStart Disable – can be set to disable AutoStopStart upon vehicle start-up 0-30 and 0-60 timers
Cooldown mode – run engine fans when Jeep is off, to aid in cooldown

Free USB updates – certainly more to come!

Add To Cart